Wanted to share this with everyone. I finished my first open loop this weekend and I think it turned out great! Bending the PETG wasnt as difficult as I thought it would be. Having a completely open case helped too lol.
Wanted to share this with everyone. I finished my first open loop this weekend and I think it turned out great! Bending the PETG wasnt as difficult as I thought it would be. Having a completely open case helped too lol.
Woah, that looks cool! Love the color choice
Looks awesome ! Not sure why but it kinda reminds me of one of those Ghostbuster backpacks ! Nice work !!
Very cool.
Intel 13700K @ 5.4GHz; Zotac RTX 4080; 32GB RAM @ 4400MHz 20-28-28-48
1 TB 990 NVMe, 500 GB 980 NVMe, 500 GB 850 & 860 EVOs; EVGA 750W Gold PS
Dell S2721DGF @ 165Hz IPS (x2)
Pulsar X2V2 Mini on Artisan Zero FX Soft XL
Ducky One 3 SF 65% keyboard with pre-lubed Black switches
really cool, bad azz setup!
Wow! That looks great!!!
Dang! That is nice!
Looks awesome! I dig it!
Sent from my Pixel 5 using Tapatalk
I like. Where you get all the parts?
Nice clean work. Hopefully I don't offend you with some constructive criticism. 2 points for improvement that I see are fixing the reversed flow you have on the graphics card block. In your setup your coolant will first pass over the RAM and VRM section and then enter the fin stack from the sides which is over the GPU core. This isn't a huge impact, but if your paying big money for a top of the line cooling setup you don't want to be leaving a couple degrees on the table. Lastly, that reservoir is mounted pretty close to the which will definitely add some static pressure and cost you some performance. Again probably not a whole lot.
Over all nice work you made some nice clean bends and great wire management. I wish I would have went PETG over Acrylic would have made my 9 pieces and 15 bends go a bit quicker.